Electric Connections - V2 CITY1-EVO Mode D'emploi

5.1 - ELECTRIC CONNECTIONS

m
WARNING: The installation of the unit, safety
devices and accessories must be carried out when the
power supply is disconnected
BEFORE PROCEEDING WITH THE ELECTRICAL
CONNECTIONS, READ CAREFULLY THE CHAPTERS
DEDICATED TO THE INDIVIDUAL DEVICES AVAILABLE IN
THE PAGES THAT FOLLOW.
L1 Antenna
L2 Antenna shielding
L3 START - Opening control for the connection of
control devices with N.O. contact
L4 START P. - Opening controls for pedestrian access for
the connection of control devices with N.O. contact
L5 STOP - Stop command. N.C. contact
L6 Common (-)
L7 FOT1 - Photocells type 1. N.C. contact
L8 FOT2 - Photocells type 2. N.C. contact
L9
COS1 - Safety edges type 1. N.C. contact
L10
COS2 - Safety edges type 2. N.C. contact
L11 Common (-)
E1 FCA1 - Open limit switch
motor M1
E2 FCC1 - Close limit switch
motor M1
E3 FCA2 - Open limit switch
motor M2
E4
FCC2 - Close limit switch
motor M2
E5
Common (-)
Z1 Power output 24 Vac for photocells and other
accessories
Z2 Common for accessories power supply
Z3 Photocell/optical edge TX power supply for
functional test
Z4 - Z5 Lock 12V
Z5 - Z6 Low voltage light (12Vdc - 3W)
H1 - H2
H3
H4
H5
H6
H7
H8
L
N
RM
ADI 2.0
USB
Encoder
OVERLOAD
motor M2
MAINS
F1
Encoder
motor M1
J1 - J2 - J3
- 34 -
Flashing light 230 / 120 Vac - 40W
Motor M2 (OPENING)
Motor M2 (COMMON)
Motor M2 (CLOSING)
Motor M1 (OPENING)
Motor M1 (COMMON)
Motor M1 (CLOSING)
Power phase 230V / 120V
Neutral 230V / 120V
MR receiving modules
ADI 2.0 interface
USB connector
It shows that there is an overload on accessories
power supply
It shows that the control unit is power supplied
5 A (230V versions)
8 A (120V versions)
Connectors for the LOW ENERGY module