V2 CITY1-EVO Mode D'emploi page 53

PARAMETER VALUE
r.Ch
0.0" - 1'00
C2rA
no
Si
t.SEr
0.5"- 1'00
no
SEr.S
Si
no
t.ASE
0.0"- 1'00
t.inv
no
0.5" - 1'00
t.PrE
0.5" - 1'00
no
t.PCh
no
0.5" - 1'00
DESCRIPTION
Closing door delay
During the closing phase, leaf 1 must start moving after leaf 2, to
avoid that both doors may collide.
Leaf 1 closing will be delayed for the setup time
Closing leaf 2 during delayed opening
With some gates, the second leaf is held closed by a pole, which
might become blocked if the leaf is left free while leaf 1 only is
opened.
This parameter makes it possible to exercise slight closing pressure on
leaf 2 during delayed opening, so that the pole remains free.
Function deactivated
Function activated
Lock time
Before the opening phase begins, the control unit will energize the
electric lock in order to release it and enable the gate motion.
t.SEr
time will fix the energizing time.
m
WARNING: in case the gate has no electric lock, set the
no
value
Function deactivated
Silent Locking Mode
Function activated (140 Hz)
Function deactivated (50 Hz)
Lock advance time
While the electric lock is energized, the gate will stay standstill for
t.ASE
time, to make its release easier.
t.ASE t.SEr
In case is lower than
while the doors will start moving.
m
WARNING: in case the gate has no electric lock, set the value
0.0"
Backlash time
Function deactivated
To facilitate uncoupling of the electrical lock, it may be useful to
control the motors before starting opening for a short time.
The control unit controls the motors in reduced power in closing
direction for the setup time
Pre-blinking time
Before any gate movement, blinker will be activated for
to warn about the incoming motion
Function deactivated
Different closing pre-flashing time
The closing pre-flashing time corresponds to
If this parameter has a value assigned to it, the control unit will
activate pre-flashing prior to closure for the length of time set in this
menu
, the lock energizing will go on
t.PrE
t.PrE
- 51 -
AntE SCor
3.0" 0.0"
no no
2.0" no
Si Si
1.0" 0.0"
no no
1.0" 1.0"
time,
no no
MEMO