Construction Of The Ball Light; Replacing The Bulb - Storch 60 10 10 Mode D'emploi

Construction of the ball light

The ball light can be placed on the floor or suspended by a hook and used as a ceiling
light.
The two sockets are suitable for connecting other electrical equipment. The total maxi-
mum connected load is 3,500 watts.

Replacing the bulb

To install/replace the bulb first unplug the device from the mains outlet.
Please note that the housing may become hot during operation – allow enough time for
the device to cool down before touching it.
Open and remove the lamp cover .
Do NOT touch the bulb with your bare fingers – use a piece of cloth or wear gloves.
Only use bulbs that are suitable for this device.
After replacing the bulb reattach the bulb cover.
29