Nice IT4WIFI Instructions Et Avertissements Pour L'installation Et L'utilisation page 5

4
INITIAL SET-UP
To configure the IT4WIFI with the HomeKit technology:
• to use the Apple "Home" app, visit the website https://support.apple.com/en-us/HT204893
• to use the "MyNice Welcome HK" app, download it from Apple Store then follow the instructions described in Chapter 4.1 - Table 2
The "Home" app can manage all HomeKit-enabled accessories, while the "MyNice Welcome HK" app only manages Nice HomeKit-enabled accessories.
Caution! - In the HomeKit technology, the Stop control is only available if the MyNice Welcome HK app is used.
To configure the IT4WIFI with the MyNice in Android technology:
• download the "MyNice Welcome" app from Google Play then follow the instructions described in Chapter 4.2 - Table 3
To configure the IT4WIFI with the MyNice in iOS technology:
• download the "MyNice Welcome" app from Apple Store then follow the instructions described in Chapter 4.3 - Table 4
4.1 - Initial set-up with HomeKit technology using the "MyNice Welcome HK" app
To run the procedure, the person must be near the IT4WIFI device, led L3 must be lit steady green and led L2 ashing green. Should this not be the case, run the Reset procedure
(Chapter 5). Moreover, ensure that the iPhone is connected to a Wi-Fi network that supports the Bonjour service.
Controlling this HomeKit-enabled accessory requires an iPhone with iOS 10.0 or later.
Controlling this HomeKit-enabled accessory automatically and away from home requires an Apple TV with tvOS 10.2 or later or an iPad with iOS 10.0 or later set up as a home hub.
Table 2 - iPhone with iOS 10.0 operat-
ing system and later versions
01. Open the "MyNice Wel-
come HK" app and select
Start with your first Nice
Accessory"
02. After entering the name
of a Home, from the list of
accessories, select the "Ni-
ceIT4WIFIxxxxxx" name to
be configured: de-
note the last 6 characters
of the MAC appearing on
the IT4WIFI label
03.
When requested, frame
the HomeKit code printed
on the IT4WIFI label or on
the last page of this manual
with the iPhone camera, or
enter the code manually
04. After completing the set-
up with the app, wait for
leds L1, L2 and L3 to turn
steady green. To control the
automation connected to
the IT4WIFI device, select
the "Open", "Stop", "Close"
buttons. The change of sta-
tus of the automation can
be viewed on the icon
If the procedure described does not terminate
successfully, check that the requirements indicated
at the beginning of the manual are satisfied, run the
IT4WIFI reset procedure using the P button (Chapter
5) then try again.
English – 4