Nice IT4WIFI Instructions Et Avertissements Pour L'installation Et L'utilisation page 3

2
INSTALLATION
CAUTION! – Before proceeding with the installation, make sure that the place where the IT4WIFI is installed is covered by the domestic Wi-Fi AP signal.
01.
Disconnect the power supply to the automation's control unit
02.
On the IT4WIFI device, insert the connector of the cable provided into the
BusT4 port
CAUTION! – Only use the cable provided! Do not use other types
of cables
03. Control unit with BusT4 port
P
1
OFF
L1
L2
L3
2
Control unit with IBT4N port
Caution! If the IBT4N is inserted incorrectly, it may permanently
damage the control unit!
1
L1
L2
L3
P
04.
Power the automation's control unit
05. The IT4WIFI has been correctly installed only if the L3 LED is a steady
green. The L2 LED may remain red for a few seconds and then flash green.
If this does not happen, disconnect the device and reconnect it after a few
seconds.
2
ON
English – 2