Carrera RC HD Next FPV Instructions De Montage Et D'utilisation page 22

23
When hovering, if the Quadrocopter flies for-
wards or backwards without you moving the
lever for forwards or backwards movement,
please proceed as follows: If the Quadrocop-
ter moves on its own fast or slow forwards,
press the upper right trimmer for forwards /
backwards in steps downwards. If the Quad-
rocopter moves backwards, press the trimmer
for forwards / backwards in steps upwards.
24
When hovering and without you moving the
lever for circling on the spot, if the quadrocop-
ter rotates to left or right, proceed as follows: If
the quadrocopter rotates quickly or slowly to
the left around its own axis, press the trimmer
for rotation below left in steps to the right. If
the quadrocopter rotates to the right, press the
trimmer for rotation in steps to the left.
Changing the rotor blades
25
Use a scredriver for unscrewing a rotor blade.
Make sure that you draw the rotor blade with
great care vertically upwards, and hold the
motor from below to stabilise it. Screw the ro-
tor blade firmly back on to the quadrocopter.
26
QR code for motor-change system, spare
parts and further information.
27
WARNING!
Be sure to note the marking and colour, also
the tilt angle of the rotor blades!
Front left: yellow – marking "A"
Front right: yellow – marking "B"
Rear right: black – marking "A"
Rear left: black – marking "B"
Troubleshooting
Problem: Remote control does not work.
Cause: The ON/OFF-power switch is turned "OFF".
Solution: Turn the ON/OFF-power switch "ON".
Cause: The batteries have been wrongly inserted.
Solution: Check if the batteries have been cor-
rectly inserted.
Cause: The batteries do not have enough power.
Solution: Insert new batteries.
ENGLISH
Problem: The Quadrocopter cannot be controlled
with the remote control
Cause: The power switch on the reomote con-
trol is turned "OFF".
Solution: First turn the power switch on the re-
mote control "ON".
Cause: The remote control is possibly not cor-
rectly frequency bound with the receiver on the
Quadrocopter.
Solution: Please carry out the binding procedure
as described in "Checklist for flight preparation".
Problem: The Quadrocopter does not start.
Cause: The ‚Start rotors' button has not been
pressed on the controller.
Solution: Press the ‚Start rotors' button on the
controller.
Problem: The Quadrocopter does not lift.
Cause: The rotor blades rotate too slowly.
Solution: Slide the gas lever up.
Cause: The battery´s power is not sufficient.
Solution: Charge the battery (see chapter
"Charging the battery").
Problem: During flight, the Quadrocopter loses
speed and height without any obvious reason.
Cause: The battery is too weak.
Solution: Charge the battery (see chapter
"Charging the battery").
Problem: The quadrocopter only flies in a circle
or turns over on starting.
Cause: Rotor blades incorrectly fitted or damaged.
Solution: Fit rotor blades / replace rotor blades as
described in .
27
Problem: Wifi/W-Lan connection not possible.
Cause: The battery is too weak.
Solution: Connect the battery in the model.
Bind your smartphone as described in point
with the Quadrocopter until you see the camera
live picture on the screen.
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
22
4b
16b