Carrera RC HD Next FPV Instructions De Montage Et D'utilisation page 18

4a
Charging via computer:
• Rechargeable batteries are to be removed
from the model before being charged.
• Connect the USB charging cable with the USB
port of a computer. The LED on the USB charger
cable lights green indicating that the charger unit
is correctly connected to the computer. If you
plug in a Quadrocopter with a discharged battery,
the LED on the USB charging cable no longer
lights up, showing that the Quadrocopter battery
is being charged. The USB charging cable and
the charging socket on the Quadrocopter are de-
signed to make incorrect connection impossible.
• It takes about 120 minutes to recharge a dis-
charged battery (but NOT a deep-discharged one).
When the battery is fully charged, the LED display
on the USB charger cable lights up green again.
Note: when supplied, the lipo-battery is al-
ready partially charged. So the first charging
cycle may well take less time.
It is essential to follow the connection se-
quence given above!
Undo the plugged connection on the Quad-
rocopter when you are not using the Quadro-
copter. Failure to observe this precaution may
cause battery damage!
4b
Insertion of the rechargeable batteries
into the Quadrocopter
• Open the cover of the battery compartment
with the aid of the enclosed screwdriver. Insert
the battery. Close the battery compartment.
• If the LED on the Quadrocopter flashes slowly,
you must change the battery.
Inserting the batteries in the
remote control
5
Open the battery compartment with a screw-
driver and insert the batteries in the remote
control. Please keep in mind the correct polar-
ity. Different types of batteries or new and
used batteries are not to be mixed. After hav-
ing closed the compartment you can check all
functions of the remote control with the help of
the power-switch on the front.
With the power switch turned ON and func-
tioning correctly, the top centre LED on the
remote control will light up red. If the LED con-
trol flashes slowly and an acoustic signal is
heard, the batteries in the controller must be
changed.
ENGLISH
Frequency bind between model
and remote control
6
The Carrera RC Quadrocopter and the control-
ler automatically link up renewed with every
operational start-up. If initially there are any
problems with communication between the
Carrera RC Quadrocopter and the remote con-
trol, please carry out a new frequency bind.
• Connect the battery in the model.
• WARNING! Immediately after switching it
on, place the Quadrocopter on a flat and
level surface. The gyro-system will then
set itself automatically.
• The LEDs on the quadrocopter now flash
rhythmically.
• Switch on the controller at the ON/OFF
switch.
• Push the left-hand joystick, i.e., the throttle
control, completely upwards and then com-
pletely downwards.
• The binding has now been successfully es-
tablished.
• The LED on the controller now lights contin-
uously.
• After approx. 5½ minutes, the controller
switches off. Please repeat the link proce-
dure for renewed use.
Description of the Quadrocopter
7
1. Rotor system
2. Rotor protection cage
3. LEDs
4. Video camera
8
5. Battery compartment
Range of functions of the remote
control
9
1. Power switch (ON / OFF)
2. Control LED
3. Gas
Circling
4. Forwards / backwards
right / left banking
5. Trimmer for right / left banking
6. Trimmer for forwards / backwards
7. Trimmer for rotation
8. Looping Button
9. Headless Mode
10. Start rotor' button
11. 'Auto-landing' button
18