Spare Parts And Recommended Tools - L-Acoustics 8XT Manuel D'utilisation

Masquer les pouces Voir aussi pour 8XT:

Manuel utilisateur (88 pages)

Manuel d'utilisation (42 pages)

Mode d'emploi (61 pages)

Table des Matières

Les langues disponibles

8XT

COAXIAL ENCLOSURE

user manual

VERSION 1.2

6. To remove the diaphragm only: unscrew the 4 pozidrive screws from the back cover of the driver,

and pull the diaphragm out from the magnet.

To remove the full HF driver: unscrew the 2 hex screws from the heat dissipation plate, remove the HF

assembly from the LF speaker, unscrew the 2 hex screws located on the rear face of the heat dissipation plate,

remove the driver from the plate.

HF driver or diaphragm replacing procedure

1. To install a full HF driver:

Install the new driver on the heat dissipation plate

(if necessary, put additional thermal paste between the plate and the driver).

b. Screw in the 2 hex screws on the rear face of the plate.

Install the HF assembly on the LF speaker and screw in the 2 hex screws through the plate.

To install a diaphragm only:

Ensure that the voice coil gap on the driver is free from any particles.

If necessary, clean out the gap by using 2-sided tape.

b. Install the new diaphragm in the gap.

Screw the 4 pozidrive screws on the back cover of the driver.

2. Connect both cables to both new diaphragm electrical sockets: connect the short red cable to the red-

marked pin and the short black cable to the unmarked pin (both long cables are for the LF speaker).

3. Install the loudspeaker assembly in the enclosure and screw in the 4 hex screws with grower and standard

washers: into each hex screw insert a grower washer and then a standard washer (following this order)

and screw the assembly to one of the four locations.

4. Install the grill (logo oriented towards the pole mount socket) and screw in the 2 pozidrive screws

(pay attention for the tissue to slide along the inside of the cabinetry).

5. Put in place both rubber bands on the grill.

8.4