Lf Loudspeaker Service; Spare Parts And Recommended Tools - L-Acoustics KILO Manuel D'utilisation

KILO
LOW EXTENSION FOR KIVA
User Manual
VERSION 1.2
8.3

LF loudspeaker service

!
In the following procedures screw in each screw to the torque value of 5 N.m (45 in.lb
IMPORTANT
If damaged, the LF loudspeaker should be removed and replaced as described below.
LF loudspeaker removing procedure
1. Install the KILO with grill facing the table and the "KILO" label facing the user in the right way (the safety
mechanism must be located on the left side).
2. Remove the rear panel: unscrew the 12 hex screws and standard washers.
3. Disconnect both red and black cables from the loudspeaker electrical sockets: push on the spring-loaded
terminal post, remove the cable, and release the terminal post.
4. Remove the 12'' loudspeaker: unscrew the 4 hex screws as well as standard and grower washers (pay
attention to the 4 screw locations).
LF loudspeaker replacing procedure
1. Install the LF loudspeaker with red terminal post facing the white mark on the enclosure.
2. Screw in the 4 hex screws in the same locations as seen in the removing procedure (equally spaced screws):
into each hex screw insert a grower washer and then a standard washer (following this order), and screw in
the assembly to the enclosure.
3. On the LF loudspeaker electrical sockets, connect the red cable to the red pin and the black cable to the
black pin: push on the spring-loaded terminal post, insert the cable in the hole, and release the terminal post.
4. Install the rear panel with "KILO" label facing the user in the right way: screw in the 12 hex screws and
standard washers.
8.4

Spare parts and recommended tools

KILO_UM_ML_1.2
Table 3: Available spare parts
HP BM121 12" speaker - 8 Ω
HS BM121 12" recone kit
HR BM121 12" recone kit including labor
SE GRKILO Front panel complete kit
Table 4: Recommended tools for service
4 mm hex key
5 mm hex key
w w w . l - a c o u s t i c s . c o m
).
f
14 en