Invacare H112-5 Manuel De L'utilisateur page 3

3 Usage
3.1 Installing the Bath Board
WARNING:
1. Place the bath board (A) onto a hard, flat
surface.
2. Align the handle (B) with the proper mounting
hole in the bath board.
 One mounting hole is round and the
other mounting hole is square.
3. Press the bath board handle into the mounting
holes (C).
4. Ensure the handle latches securely into the bath
board.
5. Ensure the handle cannot be pulled out of the
bath board after installation.
Part No 1167609
Risk of Falling.
3
The bath board MUST BE installed properly.
ALWAYS install the bath board at least .78 in
(2 cm) away from tub fixtures.
At least .78 in (2 cm) of the bath board MUST
hang over the outside of the tub.
Maximum Tub Wall Thickness: .78 in (20
mm)
Maximum Tub Width: 24.8 in (630 mm)
Minimum Tub Width: 15.5 in (395 mm)
DO NOT use the bath board with tubs that
have no inner wall.
B
C
A
Bath Board