Philips HP6570 Mode D'emploi page 9

1 Squeeze both sides of the basic epilation cap (1) and pull it off the appliance (2) (Fig. 5).
2 Put the desired attachment on the epilating head (Fig. 6).
Note: The procedure for placing the attachments onto the appliance is the same for all attachments.
3 Press the on/off button once to switch on the epilator.
The epilator starts running at speed II, which is the most efficient speed for epilation. The
,
bottom speed setting indication II lights up (Fig. 7).
If you want to use speed I, press the on/off button a second time. The top speed setting
,
indication I lights up (Fig. 8).
Tip: Speed I is suitable for areas with little hair growth, for hard-to-reach areas and for areas where
bones are located directly beneath the skin, such as knees and ankles.
When you press the on/off button a third time, the epilator switches off.
,
4 Stretch the skin with your free hand to make the hairs stand upright.
5 Place the epilating head at an angle of 90° onto the skin with the on/off button pointing in
the direction in which you are going to move the appliance (Fig. 9).
6 Move the appliance slowly over the skin against the direction of hair growth.
- When you use the optimal performance cap, make sure that both rollers of the hair primer
always stay in contact with the skin to ensure an optimal result.
- When you use the active hairlifter with active massage, make sure the active massaging roller
and the active hairlifter always stay in contact with the skin. The massaging roller stimulates and
relaxes the skin for gentler epilation.
shaving the underarms and bikini line (HP6572 only)
Use the shave, trim and style attachment to shave sensitive areas such as the underarms and the
bikini line.
1 Press the release button (1) and remove the epilating head from the epilator (2) (Fig. 10).
Note: The shave, trim and style attachment can be removed in the same way.
2 Put the shave, trim and style attachment on the appliance and press it until it snaps home
('click'). (Fig. 11)
3 Switch on the appliance.
Note: Use speed II when you shave with the shave, trim and style attachment.
4 Stretch the skin with your free hand. When shaving the underarms, raise your arm to stretch
the skin.
5 Place the shave, trim and style attachment at an angle of 90° onto your skin with the on/off
button pointing in the direction in which you are going to move the appliance.
6 Move the appliance slowly against the direction of hair growth.
Note: Make sure that the shaving unit with integrated trimmer is always fully in contact with the skin.
- Shave your bikini line as shown in the figure (Fig. 12).
- Shave your underarms as shown in the figure. Move the appliance in different
directions. (Fig. 13)
7 When you have finished shaving, switch off the appliance and clean the shave, trim and style
attachment (see chapter 'Cleaning and maintenance').
8 Put the trimming comb on the shave, trim and style attachment when you store the
appliance.
4203.000.4504.1.indd 9
EnglisH
9
10-12-09 11:48