Setting The Clock And Delay Brew Time - Sunbeam Série BVSBEHX 23-033 Notice D'emploi

SETTING THE CLOCK AND DELAY BREW TIME

To Set the Clock:
1. Plug the power cord into a standard electrical outlet. The clock
will flash on the control panel to indicate that the time has not
been set yet.
2. Press and hold the HOUR and MINUTE buttons until you reach the
current time. The AM or PM indicator is at the left of the display
(Figures 1 and 2).
The clock is now set!
NOTE: Pressing any button before setting the clock will cause the
clock to start keeping time from 12:00 a.m. You must set the clock if
you want to use the Delay Brew feature.
To Set the Delay Brew Time:
While the display is in the clock mode, simply press the SET
DELAY button (Figure 3) and, while the DELAY BREW yellow light
is flashing, set the brew time by pressing the HOUR and MINUTE
buttons (Figure 4). The AM or PM indicator is at the left of the
clock display.
Within a few seconds the display will change
to the current time.
The Delay Brew Time is now set!
NOTE: To activate the DELAY BREW cycle,
see the Brewing Coffee Later section.
To check the programmed time, push the SET DELAY button.
The display will show the time you have programmed the coffee
to brew. If you press the SET DELAY button again or wait a few
seconds, the display will switch back.
F 1
igure
F 2
igure
F 3
igure
F 4
igure
9