Brewing Coffee Later (Delay Brew) - Sunbeam Série BVSBEHX 23-033 Notice D'emploi

BREWING COFFEE LATER
1. You must first set the time for when you would like
the coffeemaker to begin brewing your coffee as
described in Setting the Clock and
the Delay Brew Timer section.
2. Prepare your coffeemaker as described in Adding
Water and Ground Coffee section.
3. To activate DELAY BREW and program your
coffeemaker to brew coffee at a later time, press the
SELECT button twice (Figure 9). The yellow DELAY
BREW light will turn on. The coffeemaker is now set
to automatically brew coffee at the pre-set later
time. At this time the brew strength light will turn on.
You can select the strength that you desire by pressing
the BREW STRENGTH button.
4. At the pre-set time, the green BREW NOW light will
turn on and the DELAY BREW yellow light will turn
off, indicating the brewing has started in the selected
brew strength. The FRESH BREW
start.
5. The coffeemaker warmer plate will keep your coffee hot for
2 hours and then automatically turn off. Thermal models will
turn off at the end of the brew cycle.
NOTE: Scalding may occur if the lid is removed during
brewing cycles.
As a safety feature, your coffeemaker will NOT start
again automatically the next day. If you
want your coffee to brew at the same time the
following day, simply add a new filter, coffee
and water and set DELAY BREW, by repeating
Steps 2 and 3 above.
To cancel DELAY BREW:
Press the SELECT button until all lights turn off (Figure 9).
14
TIMER feature will
™
F 9
igure