Installing And Aligning The Appliance - Bosch B18 Série Instructions D'installation

12. Installing and aligning the appliance

m
CAUTION
Never use a cordless screwdriver!
Risk of damage to the appliance.
NOTE
– Do not twist or jam the appliance inside the cavity!
When unscrewing the height-adjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
– The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
– If using a wooden beam as an alternative anti-tip
device according to point 6 of this installation
manual, rotate the appliance all the way towards the
wooden beam.
Align the appliance with the furniture fronts.
̈
Place marking-out level over the installation aid parts on
the door.
26
The installation aid parts on the door have been designed for
the following total thickness of furniture doors:
m
3
– / " (19 mm)
4
1
– 1 / " (38 mm)
2
Always take account of the possible differing thickness of the
furniture fronts which are to be fitted subsequently.
The height-adjustable feet at the front and rear can all be
adjusted from the front.
Front:with open-ended wrench
5
Rear:with /
16
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting the
height, align this mark at a height of 1
the floor.
Unscrew the height-adjustable feet until the mark on
̈
the base has reached the indicated guide dimension
1
(1 / " / 32 mm).
4
It is very important to comply with this dimension for
the subsequent alignment of the furniture fronts.
Align the furniture fronts with the spirit level.
̈
1
/ " (SW13)
2
" (8 mm) hex nut driver via flexible shaft.
1
/ " (32 mm) above
2
NOTE