Checking That The Finger Guard Moves Easily; Connecting The Water To The Appliance - Bosch B18 Série Instructions D'installation

15. Checking that the finger guard
moves easily
It is now essential to check that the finger guard moves
easily. At a later time any required corrections will be more
difficult.
Push the finger guard on the hinge side into the gap
̈
between the appliance and cavity wall.
It must be possible to push in and pull out the finger
guard easily!
16. Connecting the water to the
appliance
m
CAUTION
When bending the water pipe, do not kink it, otherwise
there is a risk of leaks and water damage.
NOTE
When connecting the water pipe to the solenoid valve
of the appliance, follow the instructions supplied by the
manufacturer of the ice maker installation kit enclosed
with the installation manual.
28
Remove the cap from the appliance connection (1.).
̈
Bend the water pipe according to the location of the
̈
connection on the appliance (2.).
Push the union nut and seal onto the water pipe.
̈
Push the end of the water pipe into the appliance
̈
connection and screw on the union nut (3.).
Tighten hand-tight.
Using the open-ended wrench, tighten the union nut.
̈
Do not overturn!
Open the shut-off valve and main water tap.
̈
Check the connection on the shut-off valve and on the
̈
appliance for leaks.
m