Publicité
Les langues disponibles
Les langues disponibles
CAUTION! With the machine unplugged, blow off motor with low pressure air to remove dust
or dirt. Air pressure above 50 P.S.I. should not be used as high-pressured air may damage
insulation. The operator should always wear a respirator and eye protection when using
compressed air. Do not allow chips and dust to accumulate under the machine. Keep area
clean and in safe order.
Having clean feed rollers is essential for optimal results. Check feed rollers after each use
for buildup of pitch, gum, or resin, and be sure to clean off with a non-flammable tar and
pitch remover that is not harmful to rubberized surfaces.
Periodically clean, wax, and buff the tables. This will aid in the prevention of improper feeding
of the workpiece.
HARDWARE TIGHTNESS
Periodically check all clamps, nuts, bolts, and screws, for tightness and condition. Stop the
machine and recheck the cutterhead screw and knives, or tips, for tightness after about 50
hours of operation. Recheck periodically.
GEAR LUBRICATION
The gears in the gear box should be lubricated periodically.
1.
Facing the front of the machine, remove the raise/ lower handle. SEE FIG. 1 page 13.
2.
Remove the 4 screws on the upper sides for holding the top cover on the machine.
Remove the top cover.
3.
On the left side panel, remove the 3 socket head screws (A) located around the
bottom edge and remove the side panel to expose the gearbox cover. SEE FIG 12.
A
FIG 12
MAINTENANCE
22
Publicité
