RAISING AND LOWERING HEAD ASSEMBLY
The head assembly consists of the cutterhead, knives, feed rollers, cutterhead guard, and
the motor. Raising and lowering of the head assembly controls the depth of cut on the planer.
To adjust:
1.
To raise the head assembly (A), turn the adjusting handle (B) clockwise. SEE FIG 5.
2.
To lower the head assembly, turn the adjusting handle counterclockwise.
NOTE: One revolution of the handle will move the cutterhead up or down approximately 1/16".
You can confirm this by referencing the scale (C) on the front right side of the planer.
FIG 5
ADJUSTMENTS
16
B
A
C