Publicité
Les langues disponibles
Les langues disponibles
B
A
FIG 6
A
FIG 8
THICKNESS SCALE ADJUSTMENT
The thickness scale, located on the right of the planer, shows the thickness of the finished
workpiece. To make sure the scale is set properly, run a piece of wood through the planer and
measure the thickness of the wood. If the scale is out of alignment, loosen the two round head
screws (A) holding the scale indicator (B) and adjust the thickness indicator to the correct setting.
Make sure to re-tighten the two screws once the adjustment is complete. FIG 10
FIG. 10
ADJUSTMENTS (Cont)
C
B
D
C
C
A
B
F
18
B
FIG 7
C
D
KNIFE SHARP
E
ANGLE
FIG 9
Publicité
