Publicité
Les langues disponibles
Les langues disponibles
Paragraph 15 – Level Alarm
Programming
PROG
-‐
-‐
Alarms
Level
Stop
-‐
Paragraph 16 – Flow Display Unit
Programming
Paragraph 17 - Setting the Pause
Programming
PROG
Configuration
+
Paus
-‐
N.Open
Display contrast adjustment.
For adjusting the display contrast keep the key
increase or decrease the contrast.
Hayward Flow Control
Alarm Level
-‐
Stop
Alarm Flow
Alarm
ESC
Alarms
Level
Alarm
-‐
-‐
+
-‐
pressed and within 5 seconds press the keys
www.haywardflowcontrol.com
This makes it possible to set the pump when the level
sensor alarm is activated. In other words you can decide
whether to stop dosage (Stop) or simply activate the alarm
signal without stopping dosage.
Changes can be made by pressing the
the
keys to set the alarm type. Confirm by
pressing the
key. Press
menu
This makes it possible to set the dosage unit of
measurement on the display.
Changes can be made by pressing the
the
keys to set the unit of measurement, choosing
between
L/h
(liters/hour),
(milliliters/minute) or standard (% or frequency, depending
on settings). Press
menu
The pump can be paused by remote input.
The factory setting is Normally Open.
Changes can be made by pressing the
using the
keys to set the new value ( N. OPEN or
N. CLOSED).
Press
to confirm and return to the main menu.
Operation
key, then using
to return to the main
Operation
key, then using
Gph
(Gallons/hour),
to confirm and return to the main
Operation
key, then
or
1-888-INDL (1-888-429-4635)
Pg. 11 of 12
ml/m
to
ZPDIOM
Publicité
