Publicité
Les langues disponibles
Les langues disponibles
Paragraph 8 – Timed Dosage (Frequency signal input "TRIGGER" not activated)
Programming
PROG
Configuration
Configuration
Pum functions
-
+
Pum functions
Tempo
Time
-
Quantity
100ml
Time
g.hh.mm
-
Delay
0.01.50
Time
g.hh.mm
-
Interval
0.01.50
Trigger Mode
-
Disable
Pause Input Mode
-
Restart Timer
Display during Operation
Operating mode
•
Timer
•
Alarms and Level
statuses = level alarm
•
Flow = flow alarm
Paragraph 9 – Setting the Maximum Flow
Programming
PROG
Pump Functions
-‐
Max flow rate
Max flow rate
P100%
P100%
-‐
Max flow rate
F320s/m
Hayward Flow Control
-
+
-
+
-
+
-
+
Pause Input Mode
-
Restart Timer
Pause Input Mode
-
Freeze Time
Pause Input Mode
Pause Dosing
FLOW
sensor
status
Timer
F F
F
7.0 ml
Liv
Stop
P 0%
Pump status
•
Dry = pump starting up
•
Stop = pump stopping
•
Restart = pump restarting
-‐
+
-‐
-‐
+
-‐
www.haywardflowcontrol.com
The pump doses a programmed quantity in ml. It is possible to set a
pump delay time (Delay) when the pump is started and an interval
between two successive dosings (Interval), as illustrated in the
diagram:
Delay
The Delay and Interval times are in dd.hh.mm (days, hours,
minutes)
The Pause input can be programmed in three different modes:
1. FreezeTime: when the pause is activated, the system cuts
out the current time count and restarts it when the pause is
deactivated.
2. Pause Dosing: with the pause activated, the system
continues to count time the and stops the dosing.
3. Restart Timer: when the pause is activated, the system
stops the dosing and when the pause is deactivated the
count starts again from the beginning.
The dosage frequency can be modified while the pump is operating,
by pressing the
frequency, or the
Programmed value
•
Quantity in ml
Value of dosing in
progress:
•
Percentage of
strokes/min max
This makes it possible to set the maximum flow offered by
the pump, and the programmed mode (% or frequency) is
used as the standard unit of measurement when displaying
the flow. Changes can be made by pressing the
then using the
to confirm and return to the main menu
Operation
Quantity
Interv.
keys at the same time to increase the
keys to decrease it.
Display at start-up (MODE key)
Operating mode
•
The following are shown in sequence:
quantity to dose, delay in d.hh.mm.
and interval in d.hh.mm
•
Q.tà
20,0ml
20,0ml
P 100%
Value of the dosing percentage,
which can be modified by
pressing the + or – keys
Operation
keys to set the new value. Press
1-888-INDL (1-888-429-4635)
Dosing value
Programmed
quantity in m
l
key,
ZPDIOM
Pg. 8 of 12
Publicité
