Trouble Shooting - EUROM 25.116.6 Manuel D'instruction

Pressurising:
 Unlock the pump by turning the handle 45° in an anti-clockwise direction.
 Now pressurise the liquid by pulling the pump handle upwards as far as it will go
and then pushing back down. Repeat this about 25 times in order to obtain
sufficient pressures. Lock the pump by rotating the handle 45° clockwise. The
device is now ready for use. If too much pressure has been built up, the air will
escape via the safety valve.
Spraying:
 Spraying will begin when you depress the
lever on the handle and liquid will be
released via the nozzle.
 The spray gun can be locked by sliding the
red slide on the spray gun backwards so
that you can spray continuously.
After use:
Release the remaining pressure after each use by pulling on the safety ventilator.
Ensure the trolley sprayer is upright when doing so!
 Carefully remove the filling cap (pump locked!) but be aware that residual air
may need to be released slowly.
 Remove any remaining liquid and rinse the tank, tube and hose with clean water.
Note the instructions in relation to the liquid! Leave the tank to dry.
 Ensure the trolley sprayer is always empty, clean and dry before storing indoors.
Ensure that it is not exposed to direct sunlight or frost.

Trouble shooting

If the equipment fails to work correctly, make sure the nozzle and the internal parts
of the handle are clean and that the membrane (underneath the pump section) is
not stuck.
23