EUROM 25.116.6 Manuel D'instruction page 22

Flat jet nozzle:
Sprays uniformly and is suitable for spraying
low-growing, short and creeping crops and
for spraying pesticides. Hold the jet lance
steady and spray in the same direction as
the wind is blowing. You can use the spray
cap with this nozzle.
Single atomization nozzle and double
atomization nozzle:
Are suitable for spraying pesticides (against
diseases) and insect repellents. Spray in the
same direction as the wind is blowing!
4-holes nozzle (adjustable):
Is suitable for spraying high-growing
climbing crops, fruit trees, etc. Monitor that
the liquid continues to come out of the
nozzle uniformly! By rotating the nozzle, you
can adjust the jet from a straight jet to a
spray mode.
Spray cap:
It is intended only for use on the flat jet
nozzle and it prevents spray-drifting of the
liquid. The spray cap simply slides over the
nozzle. Pay attention that the slot of the flat
jet nozzle is aligned with the wide outlet of
the spray cap!
Filling:
 Open the tank by firmly unscrewing the filler
cap (including the pump) anticlockwise off
the tank (with the spray gun in the locked
position).
Note: the funnel can be found in the cap, it
must stay in place!
 Now fill the tank with the required liquid
(following manufacturer's instructions!) and
screw the filling cap with pump back into
place. When the pump is replaced, the liquid
must remain under the safety level. If there is too much liquid the pump will be
unable to build up pressure.
22