Westfalia 316 113 300 107 Instructions De Montage page 20

GB
Installation Instructions
Electrical System for Towing Hitch
Renault Order No.:
Westfalia Order No.:
Area of Application:
General Information:
Before starting work, please read the installation instructions.
The holes drilled must be deburred and then coated with anti-corrosion paint.
The electrical set may only be installed by specially-trained personnel with the battery disconnected.
Please make sure before drilling that there is sufficient clearance behind the trim.
Important: Any electronically stored data (car radio, onboard computer etc.) may be lost.
During trailer towing the rear fog light of the pulling vehicle is switched off by the control unit.
This must be retrofitted for trailers without a rear fog lamp.
The failure of a turn signal, including on the trailer, is indicated by an increase in the flashing frequency.
As a result, no additional flashing check is required.
An electrical socket adapter may only be used during trailer towing, and must be removed after
trailer towing is completed!
The German version of these installation instructions shall be applicable in event of any legal
questions.
Subject to modification!
20
77 01 370 232
316 113 300 107 / 113 / 123
Renault Scenic Phase II
Installation time approx.60 min.
7/13-pin