IMG STAGELINE ATS-16R Mode D'emploi page 10

GB 5 Selecting the Signal Source
The transmitter can be operated with a micro-
phone, however, a unit with line output level
may also be connected.
a) Microphone operation:
– Either use the internal microphone (5)
– or connect an external microphone, the
supplied electret tie clip microphone or
the neck microphone ECM-16N (avail -
able as an accessory) to the jack MIC.
(6). When the jack is connected, the
internal microphone will be switched
off. Place the windshield on the micro-
phone and attach the microphone to
your body: attach the tie clip micro-
phone to your clothes (e. g. lapel) via its
clip or put the neck microphone around
your neck.
b) Operation with an audio unit:
Connect the output of the audio unit (e. g.
cassette recorder, CD player) via a 3.5 mm
plug to the jack AUX IN (10). When con-
necting the jack, both the internal micro-
phone and any external microphone con-
nected to the jack MIC. (6) will be switched
off.
6 Selecting the Sound Reproduction
The receiver offers different ways to repro-
duce the sound.
a) Via the internal speaker:
The sound of the speaker can either be
radiated freely or be directly transmitted to
your ear via the acoustic tube earphone
ET-16 available as an accessory. Place
the acoustic tube into the opening (5) pro-
vided on the receiver and insert the yellow
earpiece into your ear in such a way that a
tight fit is ensured.
b) Via the supplied earphone:
Connect the earphone to the jack EAR. (6)
and attach it to your ear. When con necting
the jack EAR., the internal speak er will be
switched off.
10
c) Via an amplifier system:
Connect the amplifier via a 3.5 mm plug to
the stereo jack AUX OUT (10).
Note: When connecting the jack AUX OUT,
the internal speaker is still switched on. To
switch it off, connect a 3.5 mm plug to the jack
EAR. (6).
7 Operation
1) With the adjusting wheel (3) on the trans-
mitter, select the channel for transmission
from the 16 channels (0 to F): Turn the
wheel in such a way that the arrow below it
will point to the desired channel (in fig. 1,
channel 0 is adjusted as an example).
Set the adjusting wheel (3) on the
receiver to the same channel.
2) Attach the units to your clothes, e. g. your
belt, via their clips (7).
For attaching the units to your body, the
following items are available as additional
accessories:
– ATS-16BAG, protective bag, to be at -
tached to your belt via a loop
– ATS-16CORD, neck cord (for attaching
it to the unit see fig. 3)
3) To switch on the units, turn the control (4)
clockwise from the position OFF:
On the transmitter, the LED TX (1) shows
green to indicate transmission of a radio
signal.
On the receiver, the red LED PL (2) briefly
lights up first. Then the LED RX (1) shows
Ž