Casselin CLVAD Mode D'emploi page 38

The LED can flash a message indicating operating or machine state anomalies (phase in execution). The
alarms do not prevent the operation of the cycles in progress; it is advisable to call the maintenance
technician to eliminate any abnormal operation.
Machine condition
Cycle: wash, pause, rinse
Water heater lack of heating alarm
Door open alarm during cycle
Manual drain
Regeneration cycle
Continuous washing cycle
Machine off (standby)
Regeneration alarm
Thermometer alarms (if present)
If the temperature probe is disconnected or switched off, the tank or superheater temperature display (A3-
A4) shows:
If the temperature probe is short-circuited or with a temperature greater than 107 ° C, the tank or
superheater temperature display (A3-A4) shows:
Controls
A number of checks must be carried out before using the machine.
1) Check the water level and its temperature.
2) Check the level of the detergent product.
3) Check the level of the rinse aid.
4) Check the temperature of the water supply.
5) Washing additives (do not forget to fill the supply pipes and clean the holes in the tank).
Water must be distributed at high pressure from all nozzles. The rotating wash and rinse arms must be able
to rotate unimpeded under the water pressure.
During each cycle, the detergent and rinse aid dispensers must pump the exact amount of rinse aid and
detergent. Check the liquid levels in the tanks, and if necessary, replace them or fill them to the brim. The
pump suction filter must be clean.
At the end of the cycle, the dishes, perfectly clean, must dry almost in an instant by evaporation, the basket
barely taken out of the machine.
LED condition 5
STOP
Flashing 0.3 sec
Flashing 0.5 sec
Flashing 1 sec
MARKET
Flashing 1 sec
LED condition 6
Flashing 1 sec
Flashing 1 sec
Flashing 1 sec
Flashing 1 sec
EN