Error Messages/Troubleshooting; Care, Maintenance And Storing The Instrument - Beurer BC 81 Mode D'emploi

All the values in the current user memory are deleted.
The device will then shut off.

8. Error messages/troubleshooting

If an error occurs, an "E" appears on the LCD Display
followed by a number from 1 to 6.
Error messages are as follows:
• E1 - No pulse recorded
• E2 - Movement or speaking detected during
measurement
• E3 - Cuff too tight or too loose
• E4 - Measurement error
• E5 - Inflation pressure higher than 300 mmHg
• E6 - Battery power low; replace batteries
If an error indicator appears, address the cause and
then repeat the measurement.
9. Care, maintenance and storing the
instrument
WARNING:
• Do not use any cuffs, tubes, parts and acces-
sories other than those explicitly recom-
mended by the manufacturer for use with this
product. Parts and accessories not approved
for use with the device may cause damage to
your health and to the product.
CAUTION:
• Do not disassemble the unit, it may result in
injuries.
• Clean your wrist blood pressure monitor care-
fully using a slightly damp cloth.
• Do not use any cleaning agents or solvents.
• Under no circumstances should you hold the
unit under water, as this can cause liquid to
enter and damage the unit.
• Never place any heavy objects on the device.
NOTICE:
• The blood pressure monitor is made up of pre-
cision electronic components. Accuracy of read-
ings and the instrument's service life depend on
careful handling. Protect the unit against hard
knocks (e.g. dropping the unit), moisture, water,
dirt, dust, chemicals, extreme hot or cold tem-
peratures, major temperature fluctuations, direct
exposure to sunlight and heat sources which are
26