Heater Kit Installation - Eneo VKCD-1416C Mode D'emploi

2.4 HEATER KIT INSTALLATION (option)
1. Place the Heater element in slot "A". Please ensure that the cables are facing
upwards and the heater is pointing towards the Dome.
2. Place the PCB in slot "B". Please ensure that the PCB is facing inside of the Dome
with the connection blocks at the top.
3. Place the plug in the Socket "C" (J508) which is found on the controller board.
•
HEATER (IF APPLICABLE)
Power Supply
Power Consumption
Heater ON
Heater OFF
•
POWER
Use Certified/Listed Class 2 power supply transformer only.
24VAC
20W
at 25°C (±5°C)
at 35°C (±5°C)
10