Before Installing This Navigation Unit; Installation Using The Screw Holes On The Side Of The Navigation Unit - Pioneer AVIC-F550BT Manuel D'installation

Installation
Truss head screw
(5 mm × 6 mm)
(6 pcs.)
Before installing this
navigation unit
CAUTION
The disc player will not operate properly if
you do not remove the two bolts from the na-
vigation unit. Using the disc player without
removing the bolts may cause a malfunction.
1 Remove the two shipping bolts.
2 Seal the two screw holes with the
pieces of tape supplied with the navigation
unit.
Tape
Flush surface screw
(5 mm × 7 mm)
(6 pcs.)
Installation using the screw holes
on the side of the navigation unit
% Fastening the navigation unit to the
factory radio-mounting bracket.
Position the navigation unit so that its screw
holes are aligned with the screw holes of the
bracket, and tighten the screws at three loca-
tions on each side.
If the pawl interferes with installation,
you may bend it down out of the way.
Factory radio-mounting bracket
Truss head screw or
flush surface screw
Be sure to use the
screws supplied with
this navigation
system.
Section
Dashboard or console
Engb
03
17