switel WTF 730 Mode D'emploi page 72

Operating the Walkie−Talkies
Start / End channel search
Set the CTCSS code to 0 (zero). The scan process stops at each chan-
nel on which a signal is received regardless of the CTCSS code with
which this signal was sent. Set the CTCSS code to 1 − 38 in order to ex-
clude CTCSS code 0 (zero) from the scan.
O
Two−channel monitoring
It is possible to monitor a second channel with CTCSS code in addition
to the currently set channel with CTCSS code.
Activating two−channel monitoring
7 x M
: / ;, M
: / ;, P
Both channels are scanned for signals. If an active channel is detected,
the two−channel scan stops. Channel scanning is resumed when no sig-
nal has been transmitted on the channel for five seconds.
Press the P button to enable radio communication on this channel.
Two−channel scanning is resumed when no signal has been transmitted
on the channel for five seconds.
Deactivating two−channel monitoring
7 x M
: / ; [ OF ], P Deactivate two−channel monitoring
Key tone on/off
8 x M
:/; P
Stopwatch
9 x M
:
While the stopwatch is running
:
72
Start / End channel search
Select two−channel monitoring
Select the 2nd channel and confirm
it
Select the CTCSS code for the 2nd
channel and confirm it
Select two−channel monitoring
Open the menu
Select ON / OFF and confirm it
Display the stopwatch
Start the stopwatch
Display split time