switel WTF 730 Mode D'emploi page 71

P
If you use this function with a headset, deactivate baby moni-
toring by pressing the P button.
Transmitting the ringing tone
The ringing tones indicate to other subscribers that you want to talk to
them. A condition for this is that the other subscribers are using the
same channel and CTCSS code.
T
Selecting/Deactivating ringing tones
There are 10 ringing tones available for selection. To deactivate the
ringing tone, select the setting [ OF ].
4 x M
: / ;, P
Selecting squelch level
The squelch level determines the sensitivity of the audio signals to be
transmitted through the speaker. There are 4 levels for selection. With
setting 1, even weak signals are transmitted. With setting 4, only strong
signals are transmitted. Set the required setting to prevent unwanted
background noises being played through the speaker.
6 x M
: / ;, P
Scanning for a channel
Signals are searched for in the eight channels in a continuous cycle. If
an active channel is detected, the channel scan stops.
Press the P button to enable radio communication on this
S
channel.
If you do not press the P button, channel scanning is
S
resumed five seconds after no further signal has been
transmitted on this channel.
Press the : / ; button to skip this channel.
S
Operating the Walkie−Talkies
Confirm selection and end baby
monitoring
Send ringing tones
Open the menu
Select ringing tone and confirm it
Open the menu
Select the squelch and confirm it
71