Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
¡ERROR! UTILICE LA PESTAÑA INICIO PARA APLICAR ÜBERSCHRIFT 1 AL TEXTO QUE DESEA QUE
16
TROUBLE SHOOTING
TROUBLE
Sanding belt clogs too quickly
Rounding occurs at edges or work-
piece.
Uneven thickness of right and left
sides of workpiece after sanding.
Stock slips on conveyor belt.
Shiny spots on sanded workpiece.
Marks on sanded surface of work-
piece.
Conveyor
belt
smoothly, or stops.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
REASON
does
not
run
Sanding belt grit too fine.
•
Too much material being removed in one pass.
•
Dirty workpiece suction.
•
Insufficient dust suction.
•
Workpiece contains too much moisture.
•
Too much material being removed in one pass.
•
Sanding drum is not parallel to the table.
•
Uneven wear on sanding belt
•
Too much material being removed in one pass.
•
Sanding belt grit too fine.
•
Conveyor belt is too smooth.
•
Conveyor belt tension is insufficient
•
Excessive dust accumulated on conveyor belt sur-
•
face.
Sanding belt is too worn.
•
Sanding height set incorrectly
•
Sanding belt damaged.
•
Insufficient conveyor belt tension.
•
Ponceuse à rouleau/ mini wide belt sander ZS640P/ZS970P
APAREZCA AQUÍ.
Page 34
Publicité
Table des Matières
