Maintenace - HOLZMANN MASCHINEN ZS640P Manuel D'utilisation

¡ERROR! UTILICE LA PESTAÑA INICIO PARA APLICAR ÜBERSCHRIFT 1 AL TEXTO QUE DESEA QUE
15

MAINTENACE

NOTE
Before performing any maintenance or lubrication, disconnect the machine from the power
source.
1. The table height adjustment screw shafts located at either end of the machine must be well
lubricated with grease.
2. Make sure all nuts and screws are tight before sanding. Check that the sanding belt is
mounted properly, and have not become loose or torn.
Disturbances or defects which can affect the security of the machine allow to immediately
•
remove.
The entire and regular cleaning of the machine guarantees a long life span and shows a
•
security condition. Use exclusively mild cleaning agents, i.e. no petrol, paraffin, soda etc.
...
Check regularly whether the warning tips and security tips are in the machine available
•
and in perfectly legible state
Check before every company the flawless state of the security facilities.
•
With storage of the machine this may not be kept in a humid space and must be protected
•
against the influence by weather terms.
Control all screw combinations on firm seat every week
•
Your specialist supplier does the removal of defects
•
Repair operations may be carried out only by specialist staff
•
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Do not allow excessive dust to accumulate on or in the machine.
Therefore:
Before servicing works switch off machine and from that
Tension care separate
W A R N I N G
With cleaning and maintenance with
connected machine:
Damages to property and heavy inju-
ries(violations) by unintentional turning
on of the machine possibly!
Ponceuse à rouleau/ mini wide belt sander ZS640P/ZS970P
APAREZCA AQUÍ.
Page 33