Cleaning; Disposal; Trouble Shooting - HOLZMANN MASCHINEN RSG 620 Manuel D'utilisation

15.2

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface!
Clean the machine surface with a wet cloth soaked in a mild solution
15.3

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
16

TROUBLE SHOOTING

Disconnect the machine from the power supply prior to any checks performed at the
machine itself!
Trouble
Machine stops or will not start
Machine slows down during
working
Bad grinding results
To rapid wear of
Sanding belt runs out of
sanding belt bed
Work piece burns during the
working process
MANY MALFUNCTIONS AND DEFECTS CAN BE AVOIDED BY LETTING THE MACHINE BE
CONNECTED TO YOUR POWER SUPPLY BY A CERTIFIED ELECTRICIAN
HOLZMANN MASCHINEN GmbH
Possible cause
 ON/OFF-switch damaged
 Saw unplugged
 Overload tripped
 Fuse blown or circuit breaker
tripped
 Cord damaged
 Exerting too much pressure to
the sanding abrasive
 Abrasive too coarse-grained
 Abrasive too fine-grained
 Sanding belt is mounted wrong
 Abrasive is dirty from oil
 Too much pressure
www.holzmann-maschinen.at
N O T I C E
 Check the switch
 Check all power connections
 Allow motor to cool and reset
by pushing off switch
 Change fuse or reset circuit
breake
 Change cable
 Exert less pressure on the work
piece
 Use less coarsed abrasive
 Use more coarsed abrasive
 Mount the sanding belt
centrally
 Change abrasive
 Reduce pressure
TROUBLE SHOOTING
Solution
27
RSG 620