Hazet-Werk 4902/6 Mode D'emploi page 14

GB
USA
• Insert bottom tensioning jaw
side into the coil spring (figure 1)
• Push spindle, thrust piece and drive from
below through the suspension arm and the
spring upwards until reaching the bottom
the tensioning jaw.
• Push upper tensioning jaw
spindle (figure 2).
• Lower the splindle's 6-point cap (calotte)
from the top downwards into the reception
hole of the upper tensioning jaw (figure 3).
• Check correct fit and assembly of the 6-
point cap (calotte) (figure 3).
• Pretension the system and check the
spring's tight fit all around the internal gui-
dance (figure 4).
• Operate drive with the tubular box-end
wrench and the reversible ratchet
(figure 5).
• When removing the spring from the fixing
device/rubber protectors, retain with tubu-
lar box-end wrench
ning/twisting of the tensioning jaw.
14
Design and Function
from the
onto the
in order to avoid tur-
fig. 1
fig. 2
fig. 3
fig. 4
fig. 5