The Pump Flushes Slowly; There Is Water Left In The Toilet; The Control Panel Led Is Always Red; Gurgling - Tecma X-light Manuel D'installation Et Maintenance

Operation/installation/service manual
Manuale di utilizzo / installazione / manutenzione
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige

4.4 The pump flushes slowly

Partial obstruction of the rubber sleeves may affect pump performance.

4.5 There is water left in the toilet

The check valves require a water column measuring at least 20 cm to obtain a good closing
pressure. Make sure that the system is equipped with vent valves. Make sure that the solenoid
valve closes properly. This is normal when you use an All-in-One control panel with one button.
This is normal when you use a premium control panel in mooring mode.

4.6 The control panel LED is always red

Make sure that the sensor is installed and wired properly.
In case are used TECMA pneumatic sensors, if ventilation of the blackwater tank is not sized
properly, the pressure inside the tank will increase triggering the sensor at every flush.
If the LED remains on after having removed the grey/black connector, which connects the sensor to
the control unit, there might be a problem with the control panel.

4.7 Gurgling

Make sure that the system is equipped with specific vent valves.

4.8 Leaks

Remove the toilet for an accurate inspection. Make sure that there are no cracks on the ceramic,
detect the presence of leaks in the system connections, and replace the part that leaks.

4.9 Unpleasant odours

Make sure that the unpleasant odour is actually coming from the toilet. Often, showers, bidets, and
sinks have siphons that dry quickly causing unpleasant odours.
If the unpleasant odour comes from the toilet, make sure that the system is equipped with vent
valves.
www.thetfordmarine.com
Manual rev 25.2014
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy
/
MACERATOR TOILETS
TOILET MACERATRICI
©TECMA SRL
60