Electrical System; Troubleshooting; The Toilet Is Noisy; Water Is Added But The Pump Fails To Flush - Tecma X-light Manuel D'installation Et Maintenance

Operation/installation/service manual
Manuale di utilizzo / installazione / manutenzione
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
3.7.2.2 – Electrical system
Diagram in section 8.3/8.4. Every control unit is wired by connecting
Black/brown
Black/Blue
Black/Grey
Black/Red
The ''before use'' button starts the pump, whilst the ''after use'' pump starts a program, which
activates the pump before starting the toilet motor and then activates the pump again for the final
rinse.
4.0

Troubleshooting

4.1 Toilet is noisy
The pump may be partially blocked if a solid object or paper other than toilet paper has been
flushed. Flush repeatedly. If the problem persists, open and inspect the macerator pump. Contact a
TECMA service centre, which will provide qualified assistance. Check the position of the sleeves if
the water flow generates excessive noise, especially at the end of flushing.

4.2 Water is added but the pump fails to flush

There might be a problem with the motor or control panel. Use a tester to check whether the panel
provides current to the motor or not.
If both the panel and motor run correctly, make sure that the sleeves are mounted correctly and
are not obstructed.

4.3 The pump flushes but water is not added

There might be a problem with the solenoid valve/inlet pump or control unit. Use a tester to check
whether the control panel provides current or not. Make sure that the operating pressure of the
system is within the parameters indicated in section 7.0.
www.thetfordmarine.com
Manual rev 25.2014
toilet motor
Inlet pump
Tank sensor
Power supply (with fuse on the red wire)
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy
/
MACERATOR TOILETS
TOILET MACERATRICI
©TECMA SRL
59