Equipment Required - Tecma X-light Manuel D'installation Et Maintenance

Operation/installation/service manual
Manuale di utilizzo / installazione / manutenzione
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
the sensor into place. (Note: Wires can face any direction. The direction of the sensors does not
affect its operation).
- If available follow the same procedure for the Mid-Tank sensor. However, keep in mind that it
should be assembled on the left-right centreline, approximately half way up the side of the tank.
The Full Tank Sensorhas to attached at the highest point on the tank for the tank's capacity, or
where the installer wants the Tank Full level to be.
The sensor has a removable cover over the pressure-sensitive adhesive pad.

3.6 Equipment required

- Electric drill with insert or screwdriver for the stainless steel straps.
- Electric drill or screwdriver to tighten the assembly screws
- Jig saw to make the control panel housing
- Adjustable wrench to tighten the solenoid valve
3.7 SYSTEM
Power supply: On the rear side of the product there is a label that specifies the power voltage value:
12v /24 v/110 v/230 v (refer to section 8 for electric wiring)
Clean water supply: TECMA toilets can be used with water coming from a single pump/autoclave
(centralised systems) or from a single inlet pump connected to a sea cock (single systems).
WARNING: DO NOT USE the Invensys solenoid valve with sea water
Blackwater discharge: TECMA toilets have powerful macerator pumps, which push
blackwater to the collection tanks.
WARNING: Toilet configuration (A). The toilet is installed below the floating line. Install a
VENT VALVE at a height greater than the line. See fig. 1.
www.thetfordmarine.com
Manual rev 25.2014
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy
/
MACERATOR TOILETS
TOILET MACERATRICI
©TECMA SRL
55