Touch Control Panel; One Button; Two Buttons - Tecma X-light Manuel D'installation Et Maintenance

Operation/installation/service manual
Manuale di utilizzo / installazione / manutenzione
X-light / Privilege / Evolution / Breeze / E-Breeze / Silence Plus / Elegance / Saninautico / Prestige
2.4

Touch control panel

2.4.1 One button

Press the "AFTER USE" touch button to start the automatic flush cycle, after which the toilet will be
refilled with a small amount of water, ready for the next use.

2.4.2 Two buttons

Press the "BEFORE USE" touch button before using the toilet. This will fill the toilet with a small
amount of water. Press the "AFTER USE" touch button after using the toilet. This will start the
automatic flush cycle, which will empty the toilet.
BEFORE USE
NOTE: It is also possible to adjust the amount of water used during every flushing cycle directly
from the connected remote control unit. A specific regulator placed on its rear increases the
amount of water if turned clockwise, or decreases it if turned anticlockwise.
The recommended water level is 1 cm above the ceramic outlet.
The one- and two-button Touch panels allow you to program the control panel backlight or to set
the panel on standby before starting the cleaning procedure described in paragraph 2.5.3.2.
WARNING: The tank level LED is only an indicator. Do not use the system if the LED is red.
www.thetfordmarine.com
Manual rev 25.2014
TECMA SRL – Via Flaminia / Loc Castel delle Formiche/ 05030 Otricoli (TR) / Italy
/
MACERATOR TOILETS
TOILET MACERATRICI
AFTER USE
TANK LEVEL
AFTER USE
TANK LEVEL
©TECMA SRL
39