switel BCE26 Mode D'emploi page 33

2. Receiver unit
S
Ensure that the power adapter plug is connected correctly or the
batteries have been inserted properly.
S
Place the receiver unit near the supervising adults (Fig. III).
S
Move the loudspeaker control to the required setting.
S
If a sound signal is sent by the transmitter unit, the receiver is
activated and transmits the sounds received.
S
A few seconds after the device has no longer received acoustic
signals, the receiver automatically switches back to energy save
mode.
3. Channel selection
S
Each of the units is equipped with a channel selector switch
(OFF, A or B) for the transmission of the radio signals. If
reception is poor or interference occurs in the radio signals,
select the other channel for optimum transmission.
Ensure that both units are set to the same channel.
4. Belt clip
S
The receiver unit is equipped with a belt clip.
33