Dremel MM30 Mode D'emploi page 16

DM 2610031482 05-13_MM30 5/28/13 8:11 AM Page 16
GRINDING
The diamond paper accessory
allows for the Multi-Max™ to be
used for grinding away cement,
plaster or thin set. Preparing the surface for tile
replacement is a common application for this
accessory.
The diamond paper needs to be mounted to
the backing pad prior to use.
Select a low to high speed depending on the
material removal rate desired.
The carbide rasp accessory also
allows the Multi-Max™ to grind
away cement, thinset mortar,
plaster, and also wood. This accessory is
commonly used to prepare for tile replacement
or rasping wood to smooth a surface or
remove material.
Material
All wooden materials (e.g.,
hardwood, softwood, chipboard,
building board) Metal materials–
Metal materials, fiberglass
and plastics
Paint, varnish, filling compound
and filler
Sand Paper (White)
Masonry, stone, cement
and thin set
Selecting Sanding/Grinding Sheets
Application
For coarse-sanding, e.g. of
rough, unplanned beams and
boards
For face sanding and planing
small irregularities
For finish and fine sanding of
wood
Sand Paper (Dark)
For sanding off paint
For sanding primer (e.g., for
removing brush dashes, drops
of paint and paint run)
For final sanding of primers
before coating
For smoothing, shaping and
braking edges
Diamond Paper
The speed should be set at high speed for
aggressive material removal or at low speed
for a more detailed removal of material.
Do not apply excessive pressure on the tool-let
it do the work.
Corners may be finished using the tip or edge
of the selected accessory, which should
occasionally be rotated during use to distribute
the wear on the accessory and backing pad
surface.
Grind with a continuous motion and light
pressure. DO NOT apply excessive pressure -
let the tool do the work. Excessive pressure
will result in poor handling, vibration, and
premature wear on the diamond paper sheet.
-16-
Grit Size
Coarse
60
Medium
120
Fine
240
Coarse
80
Medium
120
Fine
240
Coarse
60