I-Tech T-ONE REHAB Notice D'utilisation page 142

the threshold of perception) and increasing with care until reaching
a good level of stimulation, represented by good muscle activation.
IMPORTANT: the intensity level should not be so as to cause
discomfort! The equation "more pain = more benefit" is completely
misleading and counterproductive.
Great and significant results can be obtained only through consistency and
patience.
BEAUTY6/7/8/9 • Lipolysis abdome (6), thighs (7), glutes and hips (8), arms
(9) (no-medical program)
Program widely used in beauty treatments, suitable for areas with
accumulations of fat, works by increasing blood circulation and favouring
lymphatic activity. This program increases local metabolism, having a trophic
action; helps reducing the annoying "orange peel" appearance. All supported
by a low-calorie diet. It can be used daily.
The program produces, in the middle work phase of work, sequential tonic
contractions (first CH1/CH2 and then CH3/CH4), reproducing the typical
effect of electronic lymphatic drainage. Therefore, the electrodes should be
applied as follows: CH1/CH2 at the ends of the limbs (e.g. calf or forearm) and
CH3/CH4 in the upper part (e.g. thigh or biceps brachii).
Session duration: 30 minutes.
Electrodes' positioning:
• hand extensors CH1/hand flexors CH2 – Figure 04/05 of the Positions
manual with 2 electrodes.
Biceps brachii CH3/Triceps CH4 – Figure 02/03 of the Positions
•
manual with 2 electrodes.
Calves CH1/tibial anterior CH2 – Figure 13/14 of the Positions
•
manual with 2 electrodes.
Quadriceps CH3/biceps femoris CH4 – Figure 11/12 of the Positions
•
manual with 2 electrodes.
Intensity: enough to produce good muscle contractions (not painful) in the
stimulated areas (15÷30mA).
BEAUTY10 • Tissue elasticity (no-medical program)
Program consisting of two phases that stimulates surface muscle fibres. The
frequencies used facilitate the removal of substances accumulated on the
surface of the skin, improving its dynamic appearance.
Session duration: 30 minutes.
Electrodes' positioning: place the electrodes to form a square around the
area to be treated as show in Figure 1.
IACER Srl 138 MNPG236-02