Connection Area Closing; Electrical Connection Of The Outdoor Unit; Electrical Connections - Ferroli DIAMANT M Série Manuel D'utilisation Et D'entretien

2.13 CONNECTION AREA CLOSING

After carrying out all the above-mentioned connections, reposition
the cooling connection cover case (part A - "fig. 25 -").

2.14 ELECTRICAL CONNECTION OF THE OUTDOOR UNIT

1. Remove the side panel (part A - "fig. 26 -").
2. Make the connections referring to the wiring diagrams of the unit.
3. Close the machine up again.

2.15 ELECTRICAL CONNECTIONS

• The customer must provide a separate power line for the conditioner fitted with an automatic safety device (heavy-duty circuit bre-
aker) upstream the line.
• Make sure that the power line voltage matches that indicated on the rating plate.
• The power line of all the models must be fitted with a suitably sized earth connector.
• The lines powering the fixed loads of the unit (compressor, fans, etc.) have been sized according to current legislation governing
overload and short circuit protection.
• The conductors from the power supply running directly to the input terminals of the general switch must be connected (consult the
wiring diagrams supplied with the unit).
• The electrical panels are fitted with a terminal for connecting the earth wire, identified by the marking
38
EN
fig. 25 -
fig. 26 -
.
Cod. 3QE46140 - Rev. Cod. 3QE461