Eschenbach smartlux DIGITAL Mode D'emploi page 25

Setting the display mode
The smartlux DIGITAL is equipped with a range of display modes so that you can achieve the best possible image. If you
press the contrast button (r) briefly and repeatedly, you will run through the various display modes from true colour
mode through increased contrast mode black/white and white/black up to false colour display black/yellow and yellow/
black.
Switching the LED illumination on/off
There are two LEDs (i) on the underside of the smartlux DIGITAL which illuminate the subject material to enable opti-
mum contrasting and true-colour images. Under certain circumstances (e.g. glossy subject material) it may be necessary
to switch the LED illumination off to avoid point reflections.
To do this, press and hold the contrast button (r) for 3 seconds.
If you want to switch the LED illumination on again, press and hold the contrast button for a further 3 seconds. The LED illumina-
tion status currently set will be displayed at the top screen border for 5 seconds.
LED illumination switched on LED illumination switched off
Freezing and saving images
The smartlux DIGITAL is equipped with a photo button (w) which enables you to temporarily freeze images and then save
them permanently on the device (photo mode).
- 25 -