Malfunctions And Troubleshooting - Boneco H700 Mode D'emploi

MALFUNCTIONS AND TROUBLESHOOTING

Problem Possible cause
Air has an unpleasant Stagnant water in the tank and water base
odor
No improvement in air Particle sensor is dirty
quality
Open windows or doors
Display shows Error E2 Fan blade blocked or motor is defective
Display shows Error E3 Drum blocked or motor is defective
Display more frequent-
Water has been in the water base for more than
ly shows symbol for
4 days without operation
water change
Water was not changed after cleaning (see
page 59)
Action
Empty and thoroughly clean the appliance
Clean the particle sensor
Close windows and doors
Unplug the appliance, check that the fan blade can turn freely, plug the
appliance back in; contact a service center if the problem persists
Unplug the appliance, check that the drum can turn freely, plug the appliance
back in; contact a service center if the problem persists
Empty the appliance if it is only operating in the air purification mode
Change water after each cleaning (see page 59)
67
en