Publicité
Les langues disponibles
Les langues disponibles
- Never place the device near a wall or near a partition makes of combustible materials
even if it is very well isolated.
- A distance of minimum 10 cm with the partition or the wall is necessary.
- Remove the protective film around the machine without forgetting the one on the drip
tray (n°5 on picture).
b) First starting:
During the first use, warm your machine up outside during about 30 min to evacuate
residual smokes of manufacturing oil from the metallic parts. This may emit a slight
smell for a few moments.
First cleaning
Clean the device before the first use. (See 6 Cleaning)
Connection of the device
- Check that the tension and the frequency of the electricity network suit to the values
indicated on the descriptive plate.
- Make sure that every control knob is positioned on 0.
- Check that neither the cord nor the plug are damaged
- Unwind completely the electric power cable and connect it in a plug connected with
the earth.
- The device is connected.
NB: in case of connection of the device in a plug without earth protection or directly on
the electricity network, confide its connection to a qualified person .
c) Use of device :
Elements of command and display
Command/Display
Thermostat (n°3 on picture)
Green pilot light
(n°1 on picture)
Orange pilot light
(n°2 on picture)
Never use the machine without its drip tray (n°5 on picture).
Putting on
Turn on the thermostat control knob (n°3 on picture) on the wished position: the
green pilot light (n°1 on picture) and the orange pilot light (n°2 on picture) ignite.
The machine is warming up. Once orange pilot light (n°2 on picture) is off, the ma-
chine reached the wished temperature.
Grease the plates before each cooking.
Function
On/off + Temperature setting
Machine on (pilot light on)
Machine off (pilot light off)
Machine is heating (pilot light on)
Temperature reached (pilot light off)
14
Publicité
