Maintenance Table - Stiga 85C QF Manuel D'utilisation

13. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
General cleaning and inspection
Check the cutting device for wear
Check the drive belt for wear
14. TROUBLESHOOTING
PROBLEM
1.^>Abnormal
vibration during use
2.^>Uneven cutting
3.^>The cutting devices
do not engage or
do not stop quickly
when disengaged.
If problems persist after the operations above have been performed, contact your dealer.
PROBABLE CAUSE
Loose parts or damaged
cutting devices
The cutting means assy is full of grass.
Inefficiency of the cutting means
Forward speed too high in relation
to the height of the grass being cut
Problems with the engaging system
or the cutting means drive belt.
Frequency
First time
-
-
- At the end of each use
-
25 hours
Tighten all fasteners. Get damaged
parts replaced at an authorised
after sales service centre.
Clean the cutting means assembly
Contact your local dealer
Reduce the forward speed and/or
raise the cutting height (par. 5.1)
Wait for the grass to dry
Contact an authorised assistance centre.
EN - 10
An then after
Before each use
Before each use
Before each use
25 hours
REMEDY
Paragraph
7.3
6.2
7.4
8.1
8.2