Bosch Indego Notice Originale page 34

OBJ_BUCH-1573-008.book Page 34 Tuesday, October 27, 2015 10:35 AM
34 | English
vide for fresh air and seek medical
help in case of complaints. The va-
pours can irritate the respiratory sys-
tem.
 Store the machine only within a tem-
perature range between –20 °C and
50 °C. As an example, do not leave
the machine in the car in summer.
Safety Warnings for Docking Station
and Power Supply

Only charge via the official Bosch
docking station. Otherwise there is
danger of fire and explosion.
 Check the docking station, power
supply, cables and plugs periodi-
cally. If damage is detected, do not
use the docking station or power
supply. Never open the docking
station or power supply. Have re-
pairs performed only by a qualified
Bosch technician and only using
original spare parts. A damaged
docking station, power supply, cable
or plug increases the risk of an elec-
tric shock.
 Do not operate the docking station
and power supply on easily flam-
mable surfaces (e. g., paper, tex-
tiles, etc.) or surroundings. The
heating of the docking station and
power supply during the charging
process can pose a fire hazard.
 Warning: for the purposes of recharg-
ing the battery, only use the detacha-
ble supply unit provided with this ap-
pliance.
F 016 L81 517 | (27.10.15)
 Supervise children at all times. This
will ensure that children do not play
with the docking station, power sup-
ply or the machine.
 Children or persons that owing to
their physical, sensory or mental
limitations or to their lack of expe-
rience or knowledge, are not capa-
ble of safely operating the docking
station or power supply, may only
use this docking station and power
supply under supervision or after
having been instructed by a re-
sponsible person. Otherwise, there
is danger of operating errors and inju-
ries.

The voltage indicated on the power
supply must correspond to the volt-
age of the power source.
 The power supply should ideally be
connected into a socket that is pro-
tected by a circuit-breaker that is ac-
tuated by a 30 mA residual current.
Check your Residual Current Device
(RCD) at regular intervals.
 The supply cord must be inspected
for signs of damage at regular inter-
vals and may only be used if in perfect
condition.
 If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
 Only use or replace cables for the
docking station and power supply
with Bosch approved parts.
 Never touch the mains plug with wet
hands.
Bosch Power Tools