3
USAGE CONDITIONS
WARNING!
Read and understand all instructions.
3.1 WORK AREA
KEEP your work area clean and well lit. Cluttered benches and dark areas invite accidents.
DO NOT OPERATE power tools in explosive atmospheres, such as in the presence of flammable liquids,
gases, or dust.
KEEP bystanders, children, and visitors away while operating a power tool. Distractions can cause you to
lose control.
3.2 ELECTRICAL SAFETY
GROUNDED TOOLS MUST BE PLUGGED INTO an outlet properly installed and grounded in accordance
with all codes and ordinances.
NEVER REMOVE the grounding connection or modify the plug in any way.
DO NOT USE any adapter plugs.
CHECK with a qualified electrician if you are in doubt as to whether the outlet is properly grounded.
AVOID body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators
DO NOT ABUSE the cord. NEVER USE the cord to carry the tool.
KEEP cord away from heat, oil, sharp edges or moving parts.
REPLACE damaged cords immediately. Damaged cords increase the risk of electric shock.
WHEN OPERATING a power tool outside, use an outdoor extension cord marked "W-A", "W" or "H07RN-F".
3.3 PERSONAL SAFETY
STAY ALERT, watch what you are doing and use common sense when operating a power tool.
DO NOT USE TOOL while tired or under the influence of drugs, alcohol, or medication.
DRESS PROPERLY.
DO NOT WEAR loose clothing or jewellery.
CONTAIN long hair.
KEEP your hair, clothing, and gloves away from moving parts. Loose clothes, jewellery or long hair can be
caught in moving parts.
AVOID accidental starting.
BE SURE switch is off before plugging in. Carry tools with your finger on the switch or plugging in tools that
have the switch on invites accidents.
REMOVE adjusting keys or switches before turning the tool on.
DO NOT overreach.
KEEP proper footing and balance at all times.
USE safety equipment.
Always WEAR eye protection. Dust mask, non-skid safety shoes, hard hat, or hearing protection must be
used for appropriate conditions.
FRECUENCY CONVERTER AND POKERS
2V 38, 2V 50, 2V60, 2V70, 1V 38, 1V 50, 1V 60
en
i-SPYDER
7