Update Procedure - Ramiaudio CDM510 Manuel Utilisateur

The CDM510 update is done in four steps:
- Step 1 : Before performing the update, you can "by passing" your CDM510 device (device still powered on).
- Step 2 : Turn off the CDM510 and connect it to a computer using an USB cable type A-B. Switch on the CDM510 again,
the device is in "update" mode.
- Step 3 : CDM510 has been recognized by your computer. The new firmware must now be loaded with the supplied
"Rami-AMIX Firmware Updater" software. To do this, open the software provided and then open the "Hex"
programming file.
- Step 4 : This last step allows you to program CDM510 by clicking on the "Program" button of the "Rami-AMIX Firmware
Updater" software provided.
Once the programming is complete ("Programming / Verify Complete"), you can disconnect the USB cable from
the device.
RAMI

UPDATE PROCEDURE

BYPASS
USB
USB
The USB port allows the firmware update.
Pressing this switch allows you to force the bypass of the device
38
CDM510