Update Procedure - Ramiaudio IMV600 Manuel De L'utilisateur

UPDATE PROCEDURE

IMV600 is updated in three steps:
- Step1 : Turn off the IMV600. Connect it to a computer using a Type A-B USB cable. Switch on
the IMV600, the device is in "update" mode.
USB
- Step 2 : IMV600 has been recognized by your computer. Now you have to load the new firmware
with the supplied software "Rami-AMIX Firmware Updater". For this, open the supplied
software and then the "Hex" programming file.
- Step 3 : This last step is used to program the IMV600. To do this, click on the "Program"
button of the supplied software "Rami-AMIX Firmware Updater".
After programming is completed "Programming / Verify Complete", you can
disconnect the USB cable from the unit.
Rami
USB
USB port allows firmware update
31
IMV600